About this 3D model

DRAGON BLADE ____________________________________________________________________________________________________________________________________ About: this huge dragon blade is printable on most printers, no AMS needed! ______________________________________________________________________________________________________________________________________ STEPS TO PRINT First Print the 3 blade pieces in whatever color you want the blade to be Print the handle starting with the color of your blade. Once it pauses switch to whatever color you want the handle to be When you have all four pieces, they should all snap together. If they do not you may need to sand a little bit. If you want more strength add glue or bonding agent once all snapped together enjoy your new DRAGON BLADE __________________________________________________________________________________________________________________________________________ DIMENSIONS + Print Time + Filament used 815mm Long 145mm Wide ~14-hour total print time (.28mm , 8% infill) ~600 grams of filament used _____________________________________________________________________________________________________________________ Settings: Layer Height: .28 mm Top Shell Layer: 2 Bottom Shell Layer: 2 Infill: 8% Supports needed on handle ___________________________________________________________________________________________________________________________ Extra: Use any color you want to make a unique blade! More cool prints: mwiller | Published - MakerWorld