About this 3D model

This is the latest version of my AMS saver after bambu asked me to take down my old models. Apparently some people managed to damage the feeder leds with some of the previous models. This version mounts to the top of the feeder unit using double sided sticky tape so there is absolutely no chance of causing any damage to your AMS unit. I used the clear 1mm thick sticky tape off Temu on mine and they are stuck very well. I've been using 100mm ptfe tube with no issues, if you seem to get loading issues try 85mm. The ID of the ptfe hole is 4.2mm but because of the print orientation it can still be tight, i run an allen key through it along the top edge to smooth the layers a bit. You can play with flow rate a bit as well if too tight works best with my filament guides , the ones in the pictures i'm still testing but the originals work great Disclaimer: This is a modification to the machine and any issues caused by these mods will not be covered by Bambu.