About this 3D model

Narex Wooden Screwdriver Mount - Wall or Skadis Peg Board - 7 Piece This is my original design for the Narex 7-piece wooden screwdriver set, available here . Wall Mount Details: 4mm holes for 6G screws. 9mm wide channel for screw bit. Two versions. Standard and countersunk screws. Screw centres 130mm apart Screws appx 20mm set back into the mount. Skadis Pegboard Mount Options: Hook version and Skadis T-Nut system. T-Nut version is slightly wider so it can be centred and still fit the varied screwdriver sizes. T-nut design credit to @6d6178: link Requires 2 T-nuts from the link. Print Setup: Recommended Material: PETG for added strength (especially for the hook version), although PLA will likely be fine. Wall mount versions can be oriented with the rear of the mount on the print bed. The T-nut version does not require supports. Orient these with the back of the mount at a 45-degree angle, face of the mount flat on the print bed. Hook version: Print with the base of the mount on the print bed and with supports. Layer Height: 0.2mm with 15% grid infill. I designed this to fit specifically my set; leather gasket sizes in other sets may vary, I'm not sure. I would appreciate feedback from anyone who prints. Especially if you try it out on a different brand and it works :) Thank you to all who choose to use and provide feedback on this design. Your support and input is greatly appreciated. Affiliate Link: Narex Wooden Handle Screwdriver Set 7-Pieces