About this 3D model

I need stackable draweds for my home office corner. I couldn't find any to fit my desk, my printer and all my other preferencies. So I made one. It is still a bit of a work in progress, as the box didn't come out as solid as I'd like. So I'm going to make some adjustments, mainly a thicker upper and bottom wall. And a smaller handle. The box prints well on 0,3 layer, no supports. For the drawer, you can print at 0,3 layer, but check that the wall has 3 perimeters. It might work better on 0,2 depending on your other settings. The handle prints up side down, I used 0,2 layer and organic supports for it.