About this 3D model

This is our Gelatinous Ooze, a sectioned miniature designed to behave more like an ooze actually does in play. Instead of a single solid block, the cube is built from vertical segments that are all connected in the center. The sections can shift while staying attached, which allows you to: Settle the ooze over a miniature to show that a character has been swallowedBend the cube slightly over edges, steps, or terrain featuresGive the creature a wobbly, animated feel when you move it or pick it up at the tableYou can also give it a little shake in your hand and watch it jiggle like jelly. This model was originally released as part of our December Curations By Kira Patreon pack. What is includedYou receive the following FDM ready models: Large Gelatinous Ooze Footprint: 2 x 2 squaresSectioned, support free FDM design Huge Gelatinous Ooze Footprint: 3 x 3 squaresSectioned, support free FDM designSegmented D6 fidget Printing notesBoth gelatinous cube models are designed to print support free, because no one likes removing supports. General FDM printing recommendations Printer type: FDMOrientation: Print upright so that the segments stand verticallyMaterial: PLANozzle size: 0.4 mmLayer height: 0.2 mm Finer layer heights work as well, just adjust top and bottom layers accordinglyTop layers: 4 (0.8 mm)Bottom layers: 3 (0.6 mm)Walls: 2 (0.8 mm)Infill: 10 to 20 percent gyroid Around 20 percent lightning infill also works well if you want to save filament. Note this will make playing around with the cube significantly louder. Resin printing This design is not recommended for resin printingThe fine, interlocking internal geometry is optimized for FDM tolerances and movement, and may fuse when printed in resin Usage and licensingBy default, this product is intended for personal use only. You may print and use the physical models at your own table or as gifts, but you may not sell the STLs or redistribute the files. If you would like to sell physical 3D prints of these models as part of your shop or market booth, commercial rights are available through our Patreon: Commercial rights for this model set can be obtained by becoming an active Ancient Dragon tier supporter on the Curations By Kira PatreonThe Ancient Dragon tier provides a merchant license that covers physical print sales of Curations By Kira Patreon models while your subscription remains active, under the posted license termsSTL resale or file sharing is never permittedYou can find details and current terms on our Patreon page.