About this 3D model

I had some trouble with breaking filament while printing higher objects. I think it's because of the low temperature in my workshop and the small radius the filament is bent. So I designed this frame extension to get some distance from the spool to the extruder inlet.It's basically a socket for the frame with a slot-compatible extension on top. The right side is extended to allow a spool to be mounted, the 3 slots on the other sides can be used to mount accessories. Future extensions planned:-dust remover addon-second spool mount on rear side (only longer rod needed)-eventually: webcam mount-eventually: light mount Printed in PLA with:-concentric top and bottom fill-2 shells-3 layers (add 2-3 when you're printing slim)-10% hex infill (15 if you expect more than 2 kg weight)-NO support (just make sure you're printing not too hot to avoid bridging issues, I used 190 degrees with good results) The fit is quite tight, the 2 screw holes in the base were not needed in my case. Inspired by #166023