About this 3D model

This file is for Personal use ONLY. If you would like to sell the 3D print of this file please join my Tribe Basic Tier. On my Tribe (Basic) you will get access to all files uploaded to this tier. Here is a BEAUTIFUL can holder. It's pattern looks like it was knitted around the can you put in it. The texture of it is also so nice and satisfying while holding it. One great feature of this design is that you can fit both tall and short cans in it. The file comes with the added cylinder that you can couple with the can holder. Just put the cylinder in when putting in the short can in it, and take the cylinder out to fit the taller cans. A great incentive for you to sell that it can accommodate both sizes of cans. This was printed at 0.20mm layer height. No supports needed IMPORTANT NOTE- This file is made to fit the can very snugly. Depending on the printer AND filament that you use, this may be slightly too tight or slightly too loose. In my testing, I have found that with some filaments I have to increase my X and Y axis by 0.67%. One easy fast way to TEST that this will fit a can for your choice of filament and printer, make sure to cut the can holder close to the top in the slicer. you just need to test print about 3-5mm height of the holder and try to put a can through it. depending on the fit of the can you can then do the adjustments on the can holder. If you change the size of the can holder, make sure to only change it for the X and Y axis. Leave the Z height as is at 100%. Also don't forget to adjust the X and Y axis of the extra cylinder as well. This Can Holder was printed with The Florida Sunrise filament by Dragon Girl Designs and DUDV2