About this 3D model

This tippy tree ornament is created by combining two prints with a wall created from a plastic sheet using the template, the idea is to then put glitter in the space as to simulate a snowglobe, to get teh best effect the walls should be glued to the two pieces so that with the glitter it can be filled with water, to make the print more watertight it's best if the lower part is printed using 100% infill. the plastic template is for a wall 3.5 cm high, but it can be reduced or increasead as desired, the only importnat dimension is the length. if you don't want to open the pdf template the length is 123.40mm in teh photo it looks more like there was an avalanche, but i didn't have glitter and so i used paper-mache powder xD, with glitter the effect should be better and the walls shouldn't become foggy.