About this 3D model

The clips that I have printed so far have always been loose and moved around on the PTFE tubes and, in my opinion, they did not fulfill their role. I decided to design a clip that would fit tightly and be easy to put on. The solution was to print in the vase mode (spiral vase). I recommend using filaments with good adhesion, from what I have read, matte and silk filaments may be a problem. Settings that must be used for successful printing: Spiral vase: marked, Bottom shellleyers: 0, Slice gap closing radius: 0.002 Line width (Outer wall): 0.5 I recommend layer height: 0.28mm I printed it directly on plate and had no problem, but if you are afraid of adhesion problems, I prepared a profile with a raft. Boost Me Hey! If you like my 3D models, I’d really appreciate it if you hit Boost! ? It’s a big motivation for me to keep creating and sharing new projects with the community. Every Boost shows it’s worth it – thank you! ?