About this 3D model

Ever wanted a simple stand for your headset, but its either too low or too high up, for your particular headset? I faced this problem, and wanted to make a solution, that was scalable to my needs. This build includes the following: The base a 100 mm rod a 50 mm rod a headset top part (with a soft groove to keep your headset from sliding) a rounded top part (if you wanted to use this stand for a helmet or similar) Settings: PLA works just fine, but PETG , ASA or ABS will work fine too. Print this in 0.20 mm with everything at default. No supports required! Infill should be set to at least 15% to make the threads sturdy enough. Use a brim for the rods (if the bed does not stick) Instructions: Print 1 base and 1top. Print 1 rod at a time and use a 10mm brim if your bed does not stick that well. To make sure that the rods print perfect, they must be standing up I suggest to print 1 rod at a time, to avoid any issues. But you could try with multiple at once. 2 rods of 100mm should be sufficient for most headsets. But you can print as many rods you would like. If the threads are too tight, simply add a bit of oil.. ( Any cooking oil will work just fine ) and work the threads a bit. Tip: To check, if your printer can in fact make the threads connect, simply print 2 pieces of the 50mm rods and try it out.