About this 3D model

This purchase will grant you LIFETIME COMERCIAL LICENCE to sell the 3D print of this file forever. If you join my TRIBE you will get licence to sell 3D print of all my files including this file. NOTE: NON REFUNDABLE if you join my Tribe AFTER this purchase. Here is yet another Cat Helmet to the collections. It is an army one. It is so cute and fun to put on the cats. The Goggles print separate from the Helmet. The Helmet is wearable with or without the Goggles, your choice of how you want to Sell this item. If you choose to do both the goggles and helmet all you have to do is glue the goggles to the helmet. There are makings on either side of the helmet to help you align the goggles when gluing it on. it is best to put glue on the inside of both sides and the top of the goggles. The Goggles are made to perfectly fit the helmet. It will be attached on both sides and at the top of the goggles. I have Attached a video of how I glue it on. https://c10.patreonusercontent.com/4/patreon-media/p/post/122449426/cec693730fea4c5c9412fc41b1dfc4db/eyJhIjoxLCJwIjoxfQ%3D%3D/1.mp4?token-hash=sCwrpMGrJDNvPihl-9sF02_XVjyJCijWeVotHJrm9QI%3D&token-time=1767139200 This was printed at 0.20mm Layer height Supports recommended for the inside and the front and back edges of the helmet Supports and brim recommended for the goggles. It is set up to print upside down, so supports should be on for the whole of the bottom of the goggles and the top of the eye part. I have attached a photo of how my supports looked when I printed it