About this 3D model

[28 Jun 2024] – Update to V1.2 Change log: - Case Front has more room for the OLED screen and better alignment - Case Rear is updated to the new logo - Buttons are drafted for better fit The original case design that started it all for the Helte V3 Lora board. Recommended to print in a Matte filament to provide more grip. Install the buttons, board, SMA Pigtail and snap the 2 halves of the case together. Tap the M3x0.5 post on the ‘Case Rear’, careful not to poke through the wall at the end. Secure with a M3x12mm screw for a rock solid enclosure. No time to print? Purchase the Complete Device or Case only from my web store: https://muzi.works Fits: - Battery up to 8mm x 30mm x 48mm (Extended version: 10mm x 30mm x 48mm) - SMA Pigtail - Your choice of SMA antenna up to 10mm in diameter at the base Recommended components (complete kit): https://muzi.works/products/heltec-kit Recommended battery: https://muzi.works/products/h1-battery Dimensions: - 45.5mm x 64.6mm x 19.5mm [1.79in x 2.54in x 0.77in] - 22g [0.78oz] Meshtastic® is a registered trademark of Meshtastic LLC. Meshtastic software components are released under various licenses, see GitHub for details. No warranty is provided - use at your own risk.