About this 3D model

Boost Me If you like my model please Like, Review, Follow and Boost me! If you made my model, please Upload! Push Pin Helper Print with supports My wife always uses a hammer to put push pins in the wall. She would either break the push pin or cuss when she hit her fingers with the hammer. So, I designed this amazing push pin helper. Use it to push by hand or as my wife does, use it with a hammer. 3 different designs. V11 and V12 also work to remove pins. V11 - has a finger guard. V12 - has no guard and has a round version for the pin holder. V14 - Totally different design and super easy to use. Just insert Push pin. There is some slight wiggle room for the tack (V11 and V12). I had 2 slightly different sizes of tacks in the same container as well as slightly bent ones. The wiggle room allows for variances in tacks, but due to this you need to hold the tack in place when putting it into the wall. Check out my selection of Household Items. Colors used Green - Bambu Basic Green Bambu Studio Files Included is the studio print profile file. If you like my model please Like, Review, Follow and Boost me! If you made my model, please Upload! Commercial license As of 2/25/24 my designs are no longer allowed to be sold commercially. Do you want to sell prints of this model or any of my models? You can purchase commercial licensing at Patreon . Earring and Keychain Commercial License is just $3 a month. A full commercial license for all of my designs is just $7 a month. Designers spend a lot of time and money on design! Supporting Patreon's is a small way to help us designers out and show your appreciation for the models. Not just appreciation for what we design but the time and money we put into designing and publishing. Boost Me If you like my model please Like, Review, Follow and Boost me! If you made my model, please Upload!