About this 3D model
Assembly Assembly with BLTouch MOD head for Flying Bear Ghost 5 with 2 blower fans 4010 for better cooling of the extruded material possibility of mounting support for the installation of BLTouch Fits original Flying Bear Hotend and PCB Fanducts optimized for correct and efficient cooling of the material The project was designed to be printed without the use of supports (excluding fanducts) ________________________ Purchase list necessary for the correct assembly of the head: [2x] blower fan 4010 (recommended Gdstime model: 24V Ball 12000RPM) 1.3 Allen screwdriver DIN 7380 screws [4x] M2x5 [4x] M2x10 [2x] M2.5x14 DIN 7991 screws [1x] M2x16 [2x] M2x6 (only for model without BLTouch) [2x] M2x8 (only for model with BLTouch) [2x] M3x8 (only for model with BLTouch) [2x] M3 nuts (only for model with BLTouch) ________________________ Screws removed from the original head: DIN 912 [2x] M3x5 [2x] M3x10 DIN7380 [2x] M3x15 ________________________ Tools needed: 1.3 Allen screwdriver Allen Wrench 2 [included with Ghost 5 printer] Allen key 2.5 [included with Ghost 5 printer] Spade wrench 5,5 [included with Ghost 5 printer] - (only for model with BLTouch) ATTENTION: the screws are installed on plastic, so DO NOT OVER-TIGHTEN THE SCREWS contact me for any doubts and/or problems during installation constructive criticisms are welcome ________________________________________________________________________________________________ Assemblaggio Assemblaggio con BLTouch Testa MOD per Flying Bear Ghost 5 con 2 ventole blower 4010 per un miglior raffreddamento del materiale estruso possibilità di montare supporto per l'installazione di BLTouch Monta Hotend e PCB originali Flying Bear Fanduct ottimizzate per un corretto ed efficiente raffreddamento del materiale Il progetto è stato pensato per essere stampato senza l'uso dei supporti (fanduct escluse) ________________________ Lista acquisti necessarie per il corretto assemblaggio della testa: [2x] ventola blower 4010 (consigliate Gdstime modello: 24V Ball 12000RPM) Giravite a brugola da 1,3 Viti DIN 7380 [4x] M2x5 [4x] M2x10 [2x] M2,5x14 Viti DIN 7991 [1x] M2x16 [2x] M2x6 (solo per modello senza BLTouch) [2x] M2x8 (solo per modello con BLTouch) [2x] M3x8 (solo per modello con BLTouch) [2x] Dadi M3 (solo per modello con BLTouch) ________________________ Viti smontate dalla testa originale: DIN 912 [2x] M3x5 [2x] M3x10 DIN7380 [2x] M3x15 ________________________ Strumenti necessari: Giravite a brugola da 1,3 Chiave a brugola 2 [inclusa con stampante Ghost 5] Chiave a brugola 2,5 [inclusa con stampante Ghost 5] Chiave a forca 5,5 [inclusa con stampante Ghost 5] (solo per modello con BLTouch) ATTENZIONE : le viti sono installate su plastica, quindi NON SERRARE TROPPO LE VITI contattatemi per qualsiasi dubbio e/o problema durante l'installazione critiche costruttive sono ben accette