About this 3D model

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.24mm Brim may be used if you have adhesion problems. Filaments Used: PLA Elegoo Black PLA+ IIID Max Coyote Brown PLA+ IIID Max Vanilla Cream PLA+ IIID Max Space Gray Swap Instructions: Start with Black At layer #3 (0.4mm) swap to Coyote Brown At layer #5 (0.56mm) swap to Vanilla Cream At layer #8 (0.8mm) swap to Space Gray for the rest. Please note: Filament substitutes or changes may print with different results.