About this 3D model
Usage This storage system is designed to store the following Marvel Champions items for quick setup: Villain Dial Hero Dials x4 Confused / Stunned / Tough Cards (or tokens) Hit Point Tokens Threat Tokens All Purpose Counters Acceleration Tokens 1st Player Token It is also modular, allowing some degree of customization. If you are using custom condition tokens (instead of cards), you can simply print an extra “Tokens - Even Spacing” Tray to accommodate. Or if you are using dice for HP, you can simply ignore the dial boxes altogether. The storage stacks and locks into place with magnets and guiding tabs. Print 2x lids if you want to store this in two separate stacks to fit in the Marvel Champions box. I store mine in a Dragonshield Magic Carpet 1000 XL. This is sized to fit exactly within. The “Lid - Grip” has cut outs to allow you to lift the entire nested system out of the Magic Carpet. Due to the size restrictions for fitting in the Dragonshield box, the condition card tray does not work with sleeves . Printing To fit all standard items, print the following: 1x Villain Dial 1x Hero Dials 3x Tokens - Biased 1x for Threat 1x for HP 1x for All Purpose Counters, with the larger space for Accleration Tokens and 1st Player Marker 1x Condition Choose : 1x Condition Cards OR 1x Condition and Ready Tokens If using the Condition and Ready Tokens tray, enough space is provided for True Solo. You may need multiple trays to fit a full play set for 2 players or more. The Condition and Ready Tokens tray will hold 6x of each condition token and 12x Ready tokens I used the Condition tokens can found here 1x Lid Choose: 1x Smooth OR 1x Grip You will also need 56x Magnets sized 6mm x 2mm thk . Be very careful about the magnet polarity when installing these. All of the magnets on the top faces must be the opposite as the bottom faces (i.e. top faces of all trays is North, while the bottomf aces of all trays is South). This will allow you to nest them easily in any order.1 Due to print variability, I have oversized the magnet holes by 0.3mm. This ensures magnets will fit in in all but the worst calibration settings, but may require glue to keep stable.