About this 3D model

I really like the Brick Stackable Desk Boxes , I’ve printed many of them myself. I want to use them as screw boxes, but I feel that the boxes are not very efficient; so I’ve added a partition in the middle. This way you can make better use of the space inside. These don’t require supports and can be printed directly. Due to the different consumables, I recommend trying one out first. If the card doesn’t fit, you can reduce it to 99% and then try again. I like Brick Stackable Desk Boxes very much, and I also print a lot of them, because I want to be practical as a screw box, and I think the box is not very utilized; Therefore, a partition is added in the middle, so that you can make better use of the space inside. This does not need to be supported to print directly, according to the different consumables, it is recommended to try one first, if the card does not go in, you can reduce it to 99% and then try.