About this 3D model

If you want a commercial license, join my Commercial license club. Membership If you want a commercial license, join my Commercial license club. This is simple version of Ultimate light sword. For people who does not want to have all the CAT light things in there. Just an simple Saber design. This is first one of my series of saber desing. This Saber takes around 4h35m to print on X1C, takes around 105g of filaments. You may like this design: Ultimate Light Sword https://makerworld.com/en/models/162660#profileId-178560 Material Suggestions: I Highly suggest to use Glow in the dark filament or Translucent filament for the internal parts, and pick any color you like for the external shell. For external parts, DO NOT USE SOME BRITTLE silk filaments , it will break very easily. Some silk filaments will have very poor layer adhesion due to high speed printing cause part failure. Post Work: You will need to remove brims on both internal and external parts. Brim was added on all the printing profile to ensure the printing success rate. Print without brim is not recommaned. Installation: After you clean all the brims. follow these steps show on the gif. Design: This is a simple version of the ultimate light sword. I made a few design change on both internal and external to improve overall printing quality and have a slight different look.