About this 3D model

mounts for the various Pica pencils and markers for wall control pegboard systems the pencils sheath clicks into place allowing you to easily leave it on the wall and just remove the pencil itself wile also easily being removed with one hand when needed *** it has come to my attention that there is more than one version of the sheath used with the pica markers. if the grip on the side of your sheath is made up of 3 raised lines on each side then it will work with my models. however if it is make up of 9 raised dots than its shape wont properly match the internal geometry of my mounts. this is a centerpiece i made to fit the DDD wall control accessories system made by Allen Dersha his project can be found at https://github.com/aderusha/DDD-Printable-Wall-Control-System and https://www.printables.com/model/52618-ddd-printable-wall-control-system the rest of my accessories I've designed for the system can be found here https://makerworld.com/en/u/2234273742/collections/102156 the following parts from Allens project were used in mounting this model to my pegboard - 3x2 Angle Bracket Flat Left - 3x2 Angle Bracket Flat Center - 3x2 Angle Bracket Flat Right - 3x2 Locking Spacer - 3x5 Locking Spacer - 8mm lock pin x 6