About this 3D model

This is the Ancient Dragon Book & Tablet Display! This model is the result of a lot of refinement, and the lessons I’ve learned from my other two dragon book display variations (Flamewing and Book Wyrm). As the others are, this one also prints support-free. The dragon’s wings extend all the way down to the build plate, which adds stability and helps minimize print errors. The book prints as a separate piece, making it much faster and easier to print it in a different color. In total, there are eight different versions included, giving you a wide range of display options. Included Versions Complete dragon with slots for 6mm glass eyes (I used these- https://a.co/d/enxPFpa) Complete dragon with pre-colored, printable eyes (no inserts required) Book opening sizes: 15mm – small books or tablets35mm – medium-sized books62mm – large booksEach opening size is available with both eye options. Print Time & Filament Usage (Bambu Lab A1) Dragon ~9 hours~177g of filamentSupport-freeBook Multicolor print: ~6 hours~87g of filamentSingle-color print: ~32 minutes~7g of filament Recommended Print Settings -Layer height: 0.20mm-Walls: 3-Infill: 5% gyroid-Supports: None-In your slicer you can 'Simplify' the model to save on print time, but sacrifice detail Filament & Finish -Printed in Galaxy Dark Red filament from Panchroma (Polymaker) (https://us.polymaker.com/products/panchroma-galaxy?variant=43595081777209)-Finished with Gold Rub ’n Buff for an aged, ancient lookHappy Printing! -Christian, @CraftyKid3D