About this 3D model

Love my Milwaukee Fast back its the knife I carry around with me everyday. I never had much use for the clip attached so I removed it and just installed a bit holder to take its place. To start you will need to remove the screw that is holding the clip in place Then you will need to install this longer screw #6-32 x 1/4 in. Phillips Fillister Head Zinc Machine Screw (3-Pack) https://www.homedepot.com/p/6-32-x-1-4-in-Phillips-Fillister-Head-Zinc-Machine-Screw-3-Pack-851068/204283511 Be careful tightening it if your Printing using PLA or other non fixable filaments it can crack also when printing you may need to enable supports depending on its orientation in your slicer