About this 3D model

Elemental Dragon HueForge (Lava or Ice) Print at 100% infill with a layer height of 0.08mm with a base layer of 0.08mm Swap Instructions: Start with Black At layer #15 (1.2mm) swap to Red/Blue At layer #20 (1.6mm) swap to Orange/Cyan At layer #25 (2mm) swap to Yellow/White for the rest. Attention!!! If you print the big model on the X1/X1C, you must remove the flow calibration lines. ____________________________________________________ HueForge Elemental Dragon (Lava or Ice) Print with 100% infill with a layer height of 0.08 mm with a base layer of 0.08 mm Swap Instructions: Start with Black At layer #15 (1.2 mm) swap to Red/Blue At layer #20 (1.6 mm) swap to Orange/Cyan At layer #25 (2 mm) swap to Yellow/White for the rest. Attention!! If you print the large model on the X1/X1C, remove the flow calibration lines.