About this 3D model

I have been using Elegoo PLA+ filament but I hate the cardboard spool which seems to jam in my filament drier. The bambu filament spools seem to work much better and so I designed this jig to get the Bambu spools to work with the Elegoo cardboard filament. It may work for other brands but I haven't tested it yet Step 1: remove one side of the cardboard Elegoo spool and the inner center cardboard. Step 2: Align the jig and drill a small hole (5/32 or 4mm), about 5mm deep Step 3: Align the knob on the Bambu spool with the hole that was just drilled Step 4: Carefully flip the roll over and tear off the other side and reassemble the Bambu spool