About this 3D model

As always you can resize to your liking just make sure to disable "Uniform scale" when doing so. The Z must remain the same height otherwise it will not blend properly. Does not require an AMS, but one certainly makes this easier. Just places pauses and be ready for filament swaps. I ran this print numerous times because the print always seemed very bright vs the preview. I know the screenshot looks very orange but when printed I think it has a good brown tint to it. If you have not already learned there is a trick to doing 5+ colors with a single AMS unit, start with the first 4 colors loaded in the AMS. When you send it to the printer it will ask you to map the remaining colors, so in this case I'd recommend the 5th color, white, to the same slot as your black. For example if the black was in A1, map the white to A1 also. This will give you time to come back and swap filaments as the others print and it goes seamlessly. If you do not feel confident with remembering to do the swap you can set a reminder by manually removing the 4th color after starting the print. This will let the print start but then when it comes time for the 4th color to start the print will stop and sent you an alert. At which time you can load the 4th color and swap with the 5th color. Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA+ Esun Brown Transmission Distance: 1.5 PLA BambuLab Basic Orange Transmission Distance: 10 PLA BambuLab Basic Beige Transmission Distance: 8 PLA BambuLab Basic White Swap Instructions: Start with Black At layer #6 (0.56mm) swap to Brown At layer #8 (0.72mm) swap to Orange At layer #9 (0.80mm) swap to Beige At layer #21 (1.2mm) swap to White