About this 3D model

I developed this model to collect poop from my A1 printer in a creative and expressive way. That's my use, but yours could be for candies on the desk, desktop trash or just something fun for the kids to play with. I'm sure that you will come up with something. This model is easily scaled down (or up) when printing. I have set it up with multiple colours, but it can be a much quicker print if you print it all as one or just the tub in another colour. For that reason, I have placed the tub on its own plate. After printing and assembly, please take a couple of quick-and-nasty photos for posting here, and be sure to rate the model when Bambu tells you to. Thanks. Instructions Remove the 2 ‘mouse ears’ from the main chassis. They were there just to ensure that the end didn't pull away from the bed when printing. Use your fingers to pry apart the rails where the wheel axle is, and slide the wheel into place. This will take a bit of effort, but it can be done. Don't worry - the print will not break. Attach the tub to the chassis with super glue. The best way is to put a small dab of glue onto the rails above where the legs meet the frame. Place the tub face-down on the desk and then position the rails so that the support legs are above the tub. Be sure that you allow enough room for the wheel to rotate.