About this 3D model

Ray-Ban Meta Smart Glasses Wayfarer Nose Pad -1mm These are simple nose pads I made for the Ray-Ban Meta Wayfarer Smart Glasses. They raise the glasses up by approximately 1mm to better center my prescription lens to my eyes. If they're too thick or thin for you, use the scaling tool, uncheck “Uniform Scale” box, and adjust the Y axis as needed. Keep in mind that printing too thick will cause your glasses to not fit into the case. Don't force them in, the retaining clip will break. Print in TPU 95 or softer for more comfort. Left and riight sides are not symmetrical. The right side piece has a cutout for the microphone. Attach with double sided tape.