About this 3D model

A classic style hanging lamp. The original creator of the model is @Nikki from printables. 【Remixed】 Size scaling is 70%; Some parts have been cut or fused (for smoother printing); Some parts require supports, and the supports have been adjusted to the interior of the parts; Add a spacer to fix the LED; Add wire holes. 【Materials required】 1. 3 screws M2.5*14mm 2. 8 screws M2.5*20mm 3. Glue 4.LED light source (I use a 35mm diameter 3W warm white LED bulb powered by USB 5V. The base of the bulb is a 10mm diameter screw that can be fixed on a round spacer. You can adjust the size of this hole in bambu studio according to your needs ) 【Precautions】 Do not use too high-power LEDs. High-power LEDs will generate heat when lit for a long time, and the material may soften due to heat. Glue is necessary, but screws are not necessary (if you are sure you don’t need to disassemble it, you can use glue to bond it) This is a classic hanging lamp. The original creator of the model is @Nikki from printables. 【Modifications】 Size scaling is 70%; Some parts have been cut or fused (for smoother printing); Some parts require supports, and the supports have been adjusted to the interior of the parts; Add a spacer to fix the LED; Add wire holes. 【Materials required】 1. 3 M2.5*14mm screws 2. 8 M2.5*20mm screws 3. Glue 4. LED light source (I use a 35mm diameter 3W warm white LED bulb powered by USB 5V. The base of the bulb is a 10mm diameter screw that can be fixed on a round spacer. You can adjust the size of this hole in bambu studio according to your needs ) 【Precautions】 Do not use LEDs with too high of a wattage. High-wattage LEDs will generate heat when lit for a long time, and the material may soften due to heat. Glue is necessary, but screws are not (if you are sure you don’t need to disassemble it, you can use glue to bond it) 【Update】 2024.2.13 Optimized screw holes.