About this 3D model

INCREDIBLE RESULT for this hue forge, so beautiful. File ready to print but i write anyway: Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Matte scarlet Red Transmission Distance: 2 PLA BambuLab Matte Marine Blue Transmission Distance: 2 PLA BambuLab Basic Jade White Transmission Distance: 4 Swap Instructions: Start with Black At layer #5 (0.48mm) swap to Scarlet Red At layer #8 (0.72mm) swap to Marine Blue At layer #10 (0.88mm) swap to Jade White for the rest. Reminder: My models mostly cover the entire bed, this means the purge line is sometimes running through the bottom of the print. You have 3 options here: - Leave as is, you can just cut them of afterwards. - Remove immediately after the purge line is printed. - Scale the model: *** WARNING *** WHEN SCALING THE MODEL, BE SURE TO NOT SCALE THE Z-HEIGHT! The Z-height must always be as original, otherwise the print is messed up. If u want to support my work https://www.paypal.com/paypalme/MarcoMaineri?locale.x=it_IT For request send me dm