About this 3D model

Demogorgan Flexi Prints in some parts. while largely this is a milt colour print, with 3 colours i wanted to flesh out the back so it wasn't completley flat. so the back does require some glue, connects with just one pin mainly so the parts align correctly. ive used a bambu Matte dark brown. i would have preferred it in a more grey tone but couldn't quite find the right filament. I have also flattened off the teeth from what you see in the images as i was worried they were a little sharp. 0.2 layer Height, 10-15% infill. prints without supports