About this 3D model

This is a simple round remote control base I designed a long time ago to hang on the IKEA Skadis pegboard for remote control of the Mijia Display Lamp. The same applies to the 1s remote control. (Please disregard my actual photos, I used a different type of plate, the file I uploaded supports Skadis and most of the plates that have 35mm mesh spacing, 5mm mesh width, and 10mm hole height.) I highly recommend printing upside down, i.e., plane down, hooks up. This will leave very little support (yes, it needs support*), and placing the remote on top after removal will hide the support spout marks (yeah). Pla printing is recommended, I haven't tried petg. To remove it you can push out the remote through the hole in the bottom. If you can't remove it, you can find a thin slit on the edge of the curved bottom surface and remove it destructively from there. Again, emphasis added: Keywords: #mijia display hanging light #Ikea skadis shelf Does it need support: yes (partially) Material: pla (other materials not tried) Relevant parameters: Applicable hole mesh spacing 35mm, hole mesh width 5mm, hole height 10mm shelves. Suitable for round remote control with diameter ø66.5mm. (Mechanical translation, if there is a misunderstanding can be commented.)