About this 3D model

This is a simple project that I was able to make in a little under an hour and a half, using Fusion 360, and my Prusa Mk3. This is a simple single ring holder that I made as an entry for a contest. The design is based on the stereotypical bank vault that is often seen in TV and movies. All parts are 3D printed on my Prusa, in a combination of Prusa's gravity gray and Hatchbox gray pla. I disinged the vault to no need any supports on the inside to save as much filament as possible. The inside of the vault door wheel is taped with 3m threads. The only non-3D printed part is 1 M3*6mm socket head screw, used to hold the vault door and latch together.Affiliate link:Hatchbox gray pla https://amzn.to/3N3dQ3jSocket Head Cap Screws https://amzn.to/3ovTu9L