About this 3D model

This is a mount for a filament run out sensor for the Wanhao I3 or Monoprice Duplicator I3 series of printers, I have it mounted on a I3 Plus but it should fit the V2.1 also. It is made to fit most sensors but I used this one - https://amzn.to/2LsMdRO Requires two M3 x 18mm screws and matching nuts. There is also a area inset to allow usage of two sided tape or Velcro pads to help hold it in place on top. Print Settings Printer Brand: Wanhao Printer: Wanhao Duplicator i3 Plus Rafts: No Supports: Yes Resolution: 0.125 Infill: 35 Notes: Print on its side with supports for maximum strength. Category: 3D Printing