About this 3D model

https://www.buymeacoffee.com/maxt ---------------------- I suggest adding some felt pads to the bottom of the feet to minimize the probability of scratching your table. SETTINGS / PRINTING (recommendation) Filament: PETG or PLA. Please note that PLA can deform/break down in the sunlight. In addition, some types of PLA are biodegradable. Print: 0.2mm Nozzle: 0.4mm Support, planter: Required (approx 22 gr.), print 1x on the bottom Support, holder A and B: Not required, print on the side Brim: Not required Infill: 15-25% Perimeters: at least 2, best 3 (minimizing probability of holes and water damage to your table) Vase mode: No. While it is tempting to 3D print planters in the Vase mode, I find that there is just not enough fusion between the layers. In addition, a few micro-holes may appear during the sanding/handling of the finished planter. The water will find its way, even through a rock, so there's no reason to risk it. OTHER - If you are really worried that the planter might leak, use a waterproof sealant spray (for example Rust-Oleum Crystal Clear) inside of the planter, 3-4 coatings should be enough. You could also read the official Prusa blog post “ Watertight 3D printing PT1: Vases, cups and other open models ”. - To make the planter smooth and shiny, you could use sandpaper, prime it, (spray)paint it a couple of times and use a varnish coat on top. Happy Printing! -------------- https://www.buymeacoffee.com/maxt