About this 3D model

https://www.buymeacoffee.com/maxt ---------------------- FEMALE VERSION: https://www.printables.com/model/334054-christmas-deer-female-freestanding-use-christmas-o 2mm thick The model will fit on Prusa Mini+ (180x180) Feel free to size it up or down as you wish I strongly suggest sizing it up to fit your entire heat bed as it gives the best result The best quality is achieved if printed face down Print: 0.2mm Nozzle: 0.4mm Perimeters: 2 Support: Not needed Brim: Not needed Infill: 10% (lots of bridging) Fill pattern: Support Cubic Solid layers, top: 2 Solid layers, bottom: 2 Minimum shell thickness, top: 0.4mm Minimum shell bottom, top: 0.4mm Seam position: Rear These settings will save you at least 40% of the filament, and it will produce the same quality print. A tip: If you want to get this print easily off your heat bed, place the heat bed with the printed model in the freezer for 10 to 30 mins. Take it out, and it should pop off quite easily without any breaks/cracks, as shown on the photo below :) Base: If you print with PLA, try to size the base up by 1-2% to ensure that the holes are big enough. Happy Printing! -------------- https://www.buymeacoffee.com/maxt