About this 3D model

I've remixed this tray so it fits in the back of your Macintosh SE/30 if that's unused. This way you can access the SD card easily without having to open the case. The fit is very snug, and you can screw the board in place with a single screw like the original. Use two similar screws to fix it to the tray bracket. I've printed mine in some “beautiful” no-name orange PETG on my Bambu X1C with the following settings: 0.20mm layer height 15% gyroid infill 3 wall loops 5 bottom and top layers Original design by Alan Williams.