About this 3D model

Made this for my wife! I hope you all enjoy it! If you only have one AMS, you can get more than 4 colors by doing the following. Leave one of the colors for the print empty in the AMS in my case I left beige empty Assign the colors to their AMS slots A1 - black , A2 - Gray , A3 - Silver, A4 (unloaded) - Beige, A1 - White When you send it, the slicer will tell you some of your filaments aren't assigned just proceed anyways. When the printer gets to beige which should be unloaded, it will pause and allow you to replace all filament slots. Go ahead and load the beige and replace the black filament in slot A1 with white. Continue the print and that should be it! Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Gray Transmission Distance: 2 PLA BambuLab Basic Silver Transmission Distance: 0.5 PLA BambuLab Basic Beige Transmission Distance: 8 PLA BambuLab Basic Jade White Transmission Distance: 5 Swap Instructions: Start with Black At layer #11 (0.96mm) swap to Gray At layer #18 (1.52mm) swap to Silver At layer #25 (2.08mm) swap to Beige At layer #29 (2.4mm) swap to Jade White for the rest.