About this 3D model

? NEW v2 with Full Multi-Color support now available: https://makerworld.com/en/models/1847507-singapore-3d-miniature-v2 3d miniature of Singapore in southeast Asia! Includes an AMS-compatible multicolor print profile highlighting Marina Bay Circuit! Also includes two small pieces for the Singapore Eye and Marina Bay Sands. Personally I attached them with a tiny bit of superglue. Model created in Blender primarily using data from the Blosm addon. Check out my collection of other miniature cities: https://makerworld.com/en/u/1935755220/collections/146964 Collection of F1 Miniatures: https://makerworld.com/en/u/1935755220/collections/450282 Slicing & Printing Details This model was designed to be printed with a 0.4mm nozzle and 0.16mm layer heights. Try using a 0.2mm nozzle (0.08mm layer heights) or scaling up for even finer detail! Note : If roads or other small details disappear after slicing, try lowering the extrusion/line width of external perimeters (outer walls) closer to 0.4mm OR use Arachne walls (also try enabling “Detect Thin Walls”). Framing Details This model measures almost exactly 6.7in by 4.7in (170.5mm X 119.5mm) and should fit most 5x7 frames (assuming frame lip/overlap is around a quarter inch). Feel free to change the scale/size of the model(s) to meet your needs. Personally I use these cheap frames from Amazon: https://www.amazon.com/dp/B0C8HY7YSQ And blue printer paper: https://www.amazon.com/dp/B00006IDQT I also included a fully printable frame (including a 1mm thick water plate) designed to fit all my miniature cities. Gif of the Printable Frame A frame is not required! This model looks great by itself and can be displayed almost anywhere. Membership Become a Subscriber to obtain a Commercial License and sell physical prints of my models! License is valid as long as the subscription is active.