About this 3D model

This is a group of objects meant to extend the "Home One" briefing room diorama created by another SW 3D diorama creator (https://cults3d.com/en/3d-model/game/star-wars-home-one-briefing-diorama-for-3-75-figures). It does not include his pieces (the lower part of the diorama). The image gallery shows the the add-ons included in this release: the upper walls, holders for the circular screens, "bleacher risers," and a bottom floor. In order to use the bottom floor, you'll have to use the "add on" risers (included in this release) to the bottom of the bleacher pieces from the other creator. Also included decals to print (though I did not create them for the right two upper wall sections -- you can likely use most of the ones from the left upper walls, though). A few notes if you attempt this... the circular screen holders used to attach them to the upper walls are pretty weak, I suggest printing them in a strong plastic. I designed them a touch loose so they angle downwards just a bit when connected. The wall pieces you'll just have to glue onto his bleacher pieces. The floor I designed should slide together pretty well, though, and not need adhesive. Circle Tactical screens note: So, the release from the other creator (https://cults3d.com/en/3d-model/art/star-wars-home-one-tactical-screens-for-3-75-and-6-figures) doesn't have a clear screen, as was seen in the film. I took his piece, used a simple cylinder model to cut out the "screen" portion of his model. Then, I sliced it in half so it became 2 parts. I printed the green radar graphics on printable overhead transparency sheets, and simply sandwiched it in between the 2 pieces of the circle screen plastic when I adhered them together. Image Gallery note: I chose not to print the far right 2 sections of the entire "half circle" diorama, so photos of my prints obviously don't include those parts.