About this 3D model

This is USB cable organizer meant to be wall mounted. There are 3 versions which have different wall mounting options: The first is plain, and can be mounted with double sided tape. The 2nd design is for use with 3M command strips , it has a small cut out on the side to help with removing the command strip. The final version uses screws. The screw holes are designed for a #8 screw. The hole spacing is 59.800mm. I have only tested the plain version which I mounted with command strips, the others are just minor changes so I am confident they will work. The cable holder has 3 places for thicker cables (5mm openings) and 2 for smaller ones (4mm openings). If you need a version to support thinner, or a mix of cables, check these out: For thinner (4mm) cables - there is 3, 5 or 6 place holder here. For a mix of regular (5mm) and thin (4mm) cables - there is a 3, 5 or 6 place holder here. For a mix of regular (5mm) and thin (4mm) cables - there is a 3 and 4 place holder here. This was inspired by, though not remixed from the following designs: JKB007's USB Cable Holder https://www.thingiverse.com/thing:3022893 RMoror's USB Cable Holder (remix of JKB007's original version) https://www.thingiverse.com/thing:4130132 I printed it in the tall orientation which requires minimal supports. Seems to work fine for the cables I have on hand. STEP file is included for easy remixing. Boost Me Thanks for supporting my work! You can find the other things I'm working on at my blog here . You can also follow me here or on Printables, to see what new stuff I post. If you would like to support my work, you can Buy Me A Coffee using this link: https://www.buymeacoffee.com/mystoopidstuff Thanks for looking!