About this 3D model

Update 08 Dec. 2023: SPOOOOON! Based on DUMMY 13 Beta - Oct. 2023 DUMMY 13 Printable Jointed Figure © 2023 by Lucky 13 Toys is licensed under CC BY 4.0 Used the head to design a mask You will need the original DUMMY 13 model. Get yours from the link above. Get more: https://makerworld.com/en/u/2185604356/collections/561808 Description Content: Mask Spoooons :D Other parts are standard parts that are just printed in different colors (see pictures) Use a white head for the eyes and some paint for the skin The antennas can be bent if you heat them carefully with a hair dryer. But don't overdo it. Printing: Layer height Brim Supports Mask 0.15mm x - Spoons 0.15mm ? - Assembly: Mask: Check the inside to see if it has been printed cleanly and remove any filament debris that is sticking out Has the brim been removed cleanly? The elephant foot can cause the inner rim to be a little too narrow, just sand the inner rim down a little or work it with a knife Slide the head into the helmet and press it in with gentle force on the chin