About this 3D model

12. Feb. 2024, V1.0: First release Based on DUMMY 13 Beta - Oct. 2023 DUMMY 13 Printable Jointed Figure © 2023 by Lucky 13 Toys is licensed under CC BY 4.0 Used the waist to design a belt Description I designed this for my “DUMMY 13 goes to COMIC CON - Series" Belt Different buckles Pocket Ammo Get more: https://makerworld.com/en/u/2185604356/collections/561808 Printing: Use PLA Layer height ~0.05 mm The Belt: Print it slow (~50%) without brim and use a glue stick The quality of the first layer is crucial Assembly: If you look at the inside of the belt, you will see a kind of groove. This groove holds the belt in position above the waist Pay attention to the orientation as shown in the picture Start with edge 1 and slide it into the groove Go counterclockwise and place the belt over the waist from position 1 to 4 (use gentle force) Now put on the props and buckle that you like. You will probably need some glue Make sure not accidentally stick the parts to the waist To remove the belt, simply slide one edge on the back upwards