About this 3D model

This is a replacement housing for the windshield washer switch. With it you can install a small micro-switch in place of the usual pressure valve at the back of the windshield washer switch. This housing will fit very snugly over the existing switch component. It is designed to make it possible to not cut the existing metal rod's length and to insert a small radio shack 3a switch. Warning, due to overhang issued with many 3d printer, you will run into some droop that you will have to clean up after you print. (I would recommend warming it up a bit with a heat gun and pressing it on and quickly inserting the bolts. let it stay like that for a while until it cools.