About this 3D model

The Tumbler Wallet is slim, stylish, and securely stores up to eight cards. To use this front-pocket wallet, grip the sides with the reticle facing up, and proceed to raise one side of the top, then the other. To close the wallet, align and press together the clips on the top and bottom. Print two clips on their backs, then two more mirrored along the Y-axis, then once again flipped to their backs, with the lips up. The clips need an adhesive to be attached; while super glue may suffice, Gloop is recommended. NEW: The Gen 2 Tumbler Wallet is now available! The most common method of opening the wallet was prying the lid open. In a number of cases, depending largely on the type of filament used, that lid would snap. The Gen 2 model thickens that lid, heavily increasing its overall strength, and decreasing unintended snaps.