About this 3D model

Here's a new pokemon for my Pokemon Suspended Collection.. This time its bulbasaur.. The model is printed in multicolor and used the Bambu LED kit 001 for the lights.. You can put 2 of the LED kit on the top and bottom of the incubator.. The top part of the incubator has a dummy/support that needs to be remove so you can insert the color screen.. To assemble the suspended charmander is going to take a little patience: If you are going to install the LED kit like mine.. there will be a channel in the back side of the frame holding the suspende model.. this is for the USB cable of the LED kit.. insert the cable and carefully close the 2 half.. you should leave some slack on the top now use double sided tape on the LED kit and tape it to the top incubator.. there should be a channel for the wires too.. if you want to defuse the bright light you can use the screener i provided.. there should be grooves to insert the it.. now slowly cap the 2 half of the suspended charmander once close.. you can cap the bottom holder of the suspended model.. there should also be a channel for the USB cable lastly the place it on the bottom piece of the incubator and there is also a slot if you want to put another LED kit for the bottom.. and you done.. If you're thinking of buying the LED kit or the filaments.. please do support me by using my affliate link here.. every little purchase helps me out.. LED LAMP KIT 001 Filaments: PLA Matte Ivory white: https://shrsl.com/4hkxy PLA Matte Dark Green: https://shrsl.com/4hkxx PLA Matte Green Grass: https://shrsl.com/4hkxw PLA basic Green: https://shrsl.com/4hkxu One important thing to remember when printing suspended model is to set the wall generator to arachne from classic.. this will make the slicer print the strings.. and NO SUPPORTS.. I hope you guys have fun printing the suspended charmander.. If you would like to support me, you can join me on my buymeacoffee page.. By joining me as a supporter.. you'll be able to get behind the scenes information on my current projects as well as future projects.. And if you're looking to sell my prints.. you can join my merchant membership tier as low as USD10 a month..