About this 3D model

Hi guys, this is my first posting/sharing hope you will bare with the result or some error it mights contain. Please comment to make some correction if needed. (Result was nice on my printing, see pictures, so hopefully file is ok) Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Swap Instructions: Start with Black At layer #30 (2.48mm) swap to Red At layer #34 (2.8mm) swap to Gray At layer #39 (3.2mm) swap to White for the rest. Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Swap Instructions: Start with Black At layer #30 (2.48mm) swap to Red At layer #34 (2.8mm) swap to Gray At layer #39 (3.2mm) swap to Jade White for the rest.