About this 3D model

before downloading this, check out the improved SPOOL VUE 2.0 SPOOL VUE 2.0 - Filament Storage System by Peter Martin - MakerWorld SPOOL-VUE Filament Storage System SPOOL VUE - A WALL MOUNTED FILAMENT STORAGE / DISPLAY SYTEM. I had a few too many odd spools knocking around that wouldn't fit in my normal storage boxes so any excuse to design something new, I fired up Fusion and set about creating something different to store them. Originally it was going to be floor mounted, but quickly found out that it would need a much sturdier centre (STEEL TUBE) to stop them from tipping over when the holders are moved, then decided to go for a wall mounting system instead. There are six main parts and a screw cover in case you don't want the screws showing. I have two 12 spool racks set up and they seem to be holding up well in PLA, but may be better in PETG. These are the parts : - SPOOL VUE - BASE CONNECTOR SPOOL VUE - SPOOL HOLDER SPOOL VUE - BASE SUPPORT SPOOL VUE - MAIN CONNECTOR SPOOL VUE - TOP CONNECTOR SPOOL VUE - WALL CONNECTOR SPOOL VUE - SCREW COVER The parts all just slot into each other. To Start : slot a BASE CONNECTOR through a SPOOL HOLDER and then into a BASE SUPPORT . Then just slide on a MAIN CONNECTOR then another SPOOL HOLDER and repeat. I recommend adding a WALL CONNECTOR after every three or four Spool Holders. It does unfortunately take a lot of filament and time to print so it becomes costly to make and probably isn't something that everyone will want, just thought I'd put it up for others to try if they were so inclined. I use this to have easy access to spools once I have opened the packaging. It takes approximately 2 ½ reels of filament for a 12 spool system.