About this 3D model

Description: This weekly pill organizer throws a fun twist on the plain old pillboxes. Print out pill shape capsules that hold all of your medications you need for each day. These capsules slot nicely into a printed base with spots for each day of the week. The capsules easily pop open and when you are done, you can place them in the angled slot so you remember which you have already taken. Parts Overview: For a complete set, you will need the following: 7 female half capsules [PillF] 7 male half capsules [PillM] 1 Base plate [Full Model - Base] Printing and Assembly: This model is rather easy to print but here are a couple tips and notes: AMS is NOT needed, filament change will need to be done for the lettering Use a brim on the half capsules Support is not needed on the inside of the capsules and just makes post processing more tedious. There should be support on the outside of the male half capsule Bambu Studio gives a warning when printing the base plate on an A1 mini and says the purge tower is too close. It is very close, however I had no issues when printing. There is hardly any assembly needed. Just put the capsules together and start using. Good luck printing!