About this 3D model

It is a simple clamp to hold your headphones. Helps to keep your desk surface cleaner. Originally designed for the IKEA Adils table leg, but it can be resized and adapted to be attached to any other round poles of constant diameter. Printing tips: No supports required, given that your material can be bridged. Minimal sag is ok, it will help to make a tighter fit ;) Put left and right parts with split surfaces facing on your print bed. Use brim for better adhesion Make sure that your printer is tuned to produce dimensionally accurate results Use no-sunk variant if you don't want to use nuts Assembly: Use 2 M5x8 bolts to screw two halves on your table leg M5 Nuts are not required, but recommended if you plan to relocate this clamp multiple times The project is attached in case if you want to change dimensions or use other bolts at your disposal