About this 3D model

This print has been realized on a Prusa i3 MK3S with the following settings: For the base : 0.15 mm SPEED setting in PrusaSlicer 2.4.0 0% infill 3 perimeters Generic black PLA (Polymaker's Polymax black PLA) At the time of creation print time is around 22h for this piece. For the fan handle : 0.10 mm DETAIL setting in PrusaSlicer 2.4.0 0% infill Generic white PLA (DAGOMAS's CHROMATIK white PLA) At the time of creation print time if around a few minutes. For the fan top : 0.10 mm DETAIL setting in PrusaSlicer 2.4.0 0% infill Generic white PLA (DAGOMAS's CHROMATIK red PLA) At the time of creation print time if around a few minutes. NOTES : For some printers accuracy might hinder assembly and down-scaling of the fan parts might be handy. You can also trim the edges after print to fit the holding places. If the match is nicely done, no glue should be required for assembly. (See below)