About this 3D model

My first ever kit-card design - chess pieces as a kit-card ! Prints all flat - and then you (of the receiver of the gift) has to assemble the set . As this is my first attempt on kit-cards, please feel free to comment with suggestions for future improvements. And enjoy! Overview The kit contains all default chess pieces: King Queen Bishop Knight Rook Pawn You can print them individually OR as bigger ‘sets’ in a single card ! Assembly This should be fairly simple as all pieces only contains 3 elements: Snap/cut the elements free from the card Slide the 2 main elements together (one from the top, and the other from the bottom) Press the assembled piece down into the base (tip: do it while the base is flat on a table) If the fit is too loose, maybe a little glue can help. If it’s too tight, maybe a little sanding.. Print instructions Here is a few suggestions: Speed : Low 1. layer speed (maybe below 50% of normal - just the first layer to ensure bed adhession with all the small lines) Orientation : The cards should be oriented correctly Brim : No. Would take a long time to clean the model.. Happy printing! Want to show your support? You can see ALL my designs on Printables - and you can become an active supporter . I would really appreciate it! https://www.printables.com/@GlennovitS3D#join